| /* |
| * smdk_wm8580.c |
| * |
| * Copyright (c) 2009 Samsung Electronics Co. Ltd |
| * Author: Jaswinder Singh <jassi.brar@samsung.com> |
| * |
| * This program is free software; you can redistribute it and/or modify it |
| * under the terms of the GNU General Public License as published by the |
| * Free Software Foundation; either version 2 of the License, or (at your |
| * option) any later version. |
| */ |
| |
| #include <sound/soc.h> |
| #include <sound/pcm_params.h> |
| |
| #include <asm/mach-types.h> |
| |
| #include "../codecs/wm8580.h" |
| #include "i2s.h" |
| |
| /* |
| * Default CFG switch settings to use this driver: |
| * |
| * SMDK6410: Set CFG1 1-3 Off, CFG2 1-4 On |
| */ |
| |
| /* SMDK has a 12MHZ crystal attached to WM8580 */ |
| #define SMDK_WM8580_FREQ 12000000 |
| |
| static int smdk_hw_params(struct snd_pcm_substream *substream, |
| struct snd_pcm_hw_params *params) |
| { |
| struct snd_soc_pcm_runtime *rtd = substream->private_data; |
| struct snd_soc_dai *cpu_dai = rtd->cpu_dai; |
| struct snd_soc_dai *codec_dai = rtd->codec_dai; |
| unsigned int pll_out; |
| int bfs, rfs, ret; |
| |
| switch (params_format(params)) { |
| case SNDRV_PCM_FORMAT_U8: |
| case SNDRV_PCM_FORMAT_S8: |
| bfs = 16; |
| break; |
| case SNDRV_PCM_FORMAT_U16_LE: |
| case SNDRV_PCM_FORMAT_S16_LE: |
| bfs = 32; |
| break; |
| default: |
| return -EINVAL; |
| } |
| |
| /* The Fvco for WM8580 PLLs must fall within [90,100]MHz. |
| * This criterion can't be met if we request PLL output |
| * as {8000x256, 64000x256, 11025x256}Hz. |
| * As a wayout, we rather change rfs to a minimum value that |
| * results in (params_rate(params) * rfs), and itself, acceptable |
| * to both - the CODEC and the CPU. |
| */ |
| switch (params_rate(params)) { |
| case 16000: |
| case 22050: |
| case 32000: |
| case 44100: |
| case 48000: |
| case 88200: |
| case 96000: |
| rfs = 256; |
| break; |
| case 64000: |
| rfs = 384; |
| break; |
| case 8000: |
| case 11025: |
| rfs = 512; |
| break; |
| default: |
| return -EINVAL; |
| } |
| pll_out = params_rate(params) * rfs; |
| |
| /* Set the Codec DAI configuration */ |
| ret = snd_soc_dai_set_fmt(codec_dai, SND_SOC_DAIFMT_I2S |
| | SND_SOC_DAIFMT_NB_NF |
| | SND_SOC_DAIFMT_CBM_CFM); |
| if (ret < 0) |
| return ret; |
| |
| /* Set the AP DAI configuration */ |
| ret = snd_soc_dai_set_fmt(cpu_dai, SND_SOC_DAIFMT_I2S |
| | SND_SOC_DAIFMT_NB_NF |
| | SND_SOC_DAIFMT_CBM_CFM); |
| if (ret < 0) |
| return ret; |
| |
| /* Set WM8580 to drive MCLK from its PLLA */ |
| ret = snd_soc_dai_set_clkdiv(codec_dai, WM8580_MCLK, |
| WM8580_CLKSRC_PLLA); |
| if (ret < 0) |
| return ret; |
| |
| ret = snd_soc_dai_set_pll(codec_dai, WM8580_PLLA, 0, |
| SMDK_WM8580_FREQ, pll_out); |
| if (ret < 0) |
| return ret; |
| |
| ret = snd_soc_dai_set_sysclk(codec_dai, WM8580_CLKSRC_PLLA, |
| pll_out, SND_SOC_CLOCK_IN); |
| if (ret < 0) |
| return ret; |
| |
| return 0; |
| } |
| |
| /* |
| * SMDK WM8580 DAI operations. |
| */ |
| static struct snd_soc_ops smdk_ops = { |
| .hw_params = smdk_hw_params, |
| }; |
| |
| /* SMDK Playback widgets */ |
| static const struct snd_soc_dapm_widget wm8580_dapm_widgets_pbk[] = { |
| SND_SOC_DAPM_HP("Front", NULL), |
| SND_SOC_DAPM_HP("Center+Sub", NULL), |
| SND_SOC_DAPM_HP("Rear", NULL), |
| }; |
| |
| /* SMDK Capture widgets */ |
| static const struct snd_soc_dapm_widget wm8580_dapm_widgets_cpt[] = { |
| SND_SOC_DAPM_MIC("MicIn", NULL), |
| SND_SOC_DAPM_LINE("LineIn", NULL), |
| }; |
| |
| /* SMDK-PAIFTX connections */ |
| static const struct snd_soc_dapm_route audio_map_tx[] = { |
| /* MicIn feeds AINL */ |
| {"AINL", NULL, "MicIn"}, |
| |
| /* LineIn feeds AINL/R */ |
| {"AINL", NULL, "LineIn"}, |
| {"AINR", NULL, "LineIn"}, |
| }; |
| |
| /* SMDK-PAIFRX connections */ |
| static const struct snd_soc_dapm_route audio_map_rx[] = { |
| /* Front Left/Right are fed VOUT1L/R */ |
| {"Front", NULL, "VOUT1L"}, |
| {"Front", NULL, "VOUT1R"}, |
| |
| /* Center/Sub are fed VOUT2L/R */ |
| {"Center+Sub", NULL, "VOUT2L"}, |
| {"Center+Sub", NULL, "VOUT2R"}, |
| |
| /* Rear Left/Right are fed VOUT3L/R */ |
| {"Rear", NULL, "VOUT3L"}, |
| {"Rear", NULL, "VOUT3R"}, |
| }; |
| |
| static int smdk_wm8580_init_paiftx(struct snd_soc_pcm_runtime *rtd) |
| { |
| struct snd_soc_codec *codec = rtd->codec; |
| struct snd_soc_dapm_context *dapm = &codec->dapm; |
| |
| /* Add smdk specific Capture widgets */ |
| snd_soc_dapm_new_controls(dapm, wm8580_dapm_widgets_cpt, |
| ARRAY_SIZE(wm8580_dapm_widgets_cpt)); |
| |
| /* Set up PAIFTX audio path */ |
| snd_soc_dapm_add_routes(dapm, audio_map_tx, ARRAY_SIZE(audio_map_tx)); |
| |
| /* Enabling the microphone requires the fitting of a 0R |
| * resistor to connect the line from the microphone jack. |
| */ |
| snd_soc_dapm_disable_pin(dapm, "MicIn"); |
| |
| /* signal a DAPM event */ |
| snd_soc_dapm_sync(dapm); |
| |
| return 0; |
| } |
| |
| static int smdk_wm8580_init_paifrx(struct snd_soc_pcm_runtime *rtd) |
| { |
| struct snd_soc_codec *codec = rtd->codec; |
| struct snd_soc_dapm_context *dapm = &codec->dapm; |
| |
| /* Add smdk specific Playback widgets */ |
| snd_soc_dapm_new_controls(dapm, wm8580_dapm_widgets_pbk, |
| ARRAY_SIZE(wm8580_dapm_widgets_pbk)); |
| |
| /* Set up PAIFRX audio path */ |
| snd_soc_dapm_add_routes(dapm, audio_map_rx, ARRAY_SIZE(audio_map_rx)); |
| |
| /* signal a DAPM event */ |
| snd_soc_dapm_sync(dapm); |
| |
| return 0; |
| } |
| |
| enum { |
| PRI_PLAYBACK = 0, |
| PRI_CAPTURE, |
| SEC_PLAYBACK, |
| }; |
| |
| static struct snd_soc_dai_link smdk_dai[] = { |
| [PRI_PLAYBACK] = { /* Primary Playback i/f */ |
| .name = "WM8580 PAIF RX", |
| .stream_name = "Playback", |
| .cpu_dai_name = "samsung-i2s.0", |
| .codec_dai_name = "wm8580-hifi-playback", |
| .platform_name = "samsung-audio", |
| .codec_name = "wm8580-codec.0-001b", |
| .init = smdk_wm8580_init_paifrx, |
| .ops = &smdk_ops, |
| }, |
| [PRI_CAPTURE] = { /* Primary Capture i/f */ |
| .name = "WM8580 PAIF TX", |
| .stream_name = "Capture", |
| .cpu_dai_name = "samsung-i2s.0", |
| .codec_dai_name = "wm8580-hifi-capture", |
| .platform_name = "samsung-audio", |
| .codec_name = "wm8580-codec.0-001b", |
| .init = smdk_wm8580_init_paiftx, |
| .ops = &smdk_ops, |
| }, |
| [SEC_PLAYBACK] = { /* Sec_Fifo Playback i/f */ |
| .name = "Sec_FIFO TX", |
| .stream_name = "Playback", |
| .cpu_dai_name = "samsung-i2s.x", |
| .codec_dai_name = "wm8580-hifi-playback", |
| .platform_name = "samsung-audio", |
| .codec_name = "wm8580-codec.0-001b", |
| .init = smdk_wm8580_init_paifrx, |
| .ops = &smdk_ops, |
| }, |
| }; |
| |
| static struct snd_soc_card smdk = { |
| .name = "SMDK-I2S", |
| .dai_link = smdk_dai, |
| .num_links = 2, |
| }; |
| |
| static struct platform_device *smdk_snd_device; |
| |
| static int __init smdk_audio_init(void) |
| { |
| int ret; |
| char *str; |
| |
| if (machine_is_smdkc100() |
| || machine_is_smdkv210() || machine_is_smdkc110()) { |
| smdk.num_links = 3; |
| /* Secondary is at offset SAMSUNG_I2S_SECOFF from Primary */ |
| str = (char *)smdk_dai[SEC_PLAYBACK].cpu_dai_name; |
| str[strlen(str) - 1] = '0' + SAMSUNG_I2S_SECOFF; |
| } else if (machine_is_smdk6410()) { |
| str = (char *)smdk_dai[PRI_PLAYBACK].cpu_dai_name; |
| str[strlen(str) - 1] = '2'; |
| str = (char *)smdk_dai[PRI_CAPTURE].cpu_dai_name; |
| str[strlen(str) - 1] = '2'; |
| } |
| |
| smdk_snd_device = platform_device_alloc("soc-audio", -1); |
| if (!smdk_snd_device) |
| return -ENOMEM; |
| |
| platform_set_drvdata(smdk_snd_device, &smdk); |
| ret = platform_device_add(smdk_snd_device); |
| |
| if (ret) |
| platform_device_put(smdk_snd_device); |
| |
| return ret; |
| } |
| module_init(smdk_audio_init); |
| |
| static void __exit smdk_audio_exit(void) |
| { |
| platform_device_unregister(smdk_snd_device); |
| } |
| module_exit(smdk_audio_exit); |
| |
| MODULE_AUTHOR("Jaswinder Singh, jassi.brar@samsung.com"); |
| MODULE_DESCRIPTION("ALSA SoC SMDK WM8580"); |
| MODULE_LICENSE("GPL"); |